E4 Test Plan

"CCS Technology's test plans are the industry's only test executables that go through extensive beta testing."

Type	Test Section
Part #	11103
Description	CCStests SEMI E4 (SECS-I) Test Section is used to verify requirements as defined by SEMI® in its Equipment Automation/Software volume for the E4 (SECS-I) standard. This test section contains a set of automated, as well as manual test cases, to create positive and negative test conditions. Requires CCSenvoy for run-time.
User	Device Manufacturer: Primarily uses CCStests SEMI E4 (SECS-I) Test Section for source inspection acceptance tests or as part of delivery audit for SEMI E4 requirements. Equipment Supplier: Used by the Test Engineer who is responsible for supplier internal system and QA testing of an equipment E4 communication interface. Development Engineers may also utilize this during development integration test phases. Systems Integrator: A qualified Systems Integrator engineer would use this test section as part of the CCSpartner program for performing CCScertify services or during dry-run and integration tests.
Test Groups	CCStests SEMI E4 (SECS-I) Test Section contains over 20 automated test cases. These test cases are categorized into several test groups. The following are the test groups for the SEMI E4 (SECS-I) Test Section.
Group Outline	1. Messages Initiated from Host 2. Error Messages (S9Fx) - E4 header 3. Messages Initiated from Equipment
Licensing	End-User License Agreement (EULA) required.

Full Outline

1. TG-5688 Establish Communications

1. 1. TC-5689 Host initiated establish communications

2. TG-5690 Messages Initiated from Host

2. 1. TC-5691 Host does not respond to EOT from equipment

2. 2. TC-5692 Host sends bad length byte

2. 3. TC-5693 Host does not send data block to equipment

2. 4. TC-5694 Host sends invalid data block to equipment

2. 5. TC-5695 Host sends short checksum to equipment

2. 6. TC-5696 Host sends invalid checksum to equipment

2. 7. TC-5697 Host does not respond to ENQ of secondary response from equipment

3. TG-5698 Error Messages (S9Fx) - E4 header

3. 1. TC-5699 Message fault due to unrecognized device ID (E4).

3. 2. TC-5700 Message fault due to unrecognized stream type (E4).

3. 3. TC-5701 Message fault due to unrecognized function type (E4).

3. 4. TC-5702 Message fault due to illegal data format (E4).

3. 5. TC-5703 Communications fault due to transaction timer timeout (E4).

4. TG-5704 Messages Initiated from Equipment

4. 1. TC-5705 Host responds with bad EOT to equipment.

4. 2. TC-5706 Host responds with bad ACK to equipment.

4. 3. TC-5707 Host responds with NAK to equipment.

4. 4. TC-5708 Host does not respond to ENQ from equipment.

4. 5. TC-5709 Host does not respond with ACK to equipment.

4. 6. TC-5710 Simultaneous attempts at communication, equipment ignores ENQ.

4. 7. TC-5711 Simultaneous attempts at communication, dialog does not send EOT.